7 Series E38 740d (M67) SAL
12 61 280
Removing and installing/replacing oil
pressure switch (M67)
Necessary preliminary tasks:
•
Disconnect and connect intake air manifold.
Note:
Drain the full flow oil filter to prevent excessive oil discharge when
removing the oil pressure switch.
Disconnect all plug connections on engine wiring harness (1).
Caution!
Do not damage oil-filter cover.
Release and tighten down with a socket only.
When the full flow oil-filter cover is released, the oil flows from
the oil-filter housing back into the sump.
Release oil-filter cover and remove towards top.
Tightening torque, 11 42 2AZ
.
Installation note:
Replace sealing rings and coat with oil.
RA Removing and installing/replacing oil pressure switch (M67)
BMW AG - TIS
10.02.2013 03:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
