7 Series E38 740d (M67) SAL
Support transmission with special tool 00 2 030 / 24 0 170.
Unfasten screws and remove transmission cross-member.
Installation:
Tightening Torque,
refer to Technical Data 24 71 1AZ.
Unfasten screws.
Installation:
Replace self-locking nuts.
When tightening down screws: grip each screw and tighten
down nut. This prevents the joint disk from being
tensioned/distorted.
Tightening Torque,
refer to Technical Data 26 11 1AZ.
Brace propeller shaft on center bearing and loosen nuts.
Installation:
Center bearing must be aligned at right angles to propeller
shaft.
Tightening Torque,
refer to Technical Data 26 11 6AZ.
RA Removing and installing automatic transmission (M67 with A5S 560Z)
BMW AG - TIS
10.02.2013 04:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
