7 Series E38 740iL (M60-2) SAL
Install special tool 11 3 390 in right timing case cover.
Tighten bow cover by turning the adjusting screw on the special
tool 11 3 390 with special tool 00 9 250 to 1.3 Nm.
Note:
If installation tolerance is unfavorable, attach special
tool 00 9 250 from below.
Tighten sprockets in the following order:
1.
All screws on exhaust camshaft, left
2.
Three screws on exhaust camshaft, right
3.
All screws on inlet camshaft, left
4.
Three screws on inlet camshaft, right
Tightening torque,
refer to Technical Data 11 31 3AZ.
Remove special tools 11 2 444 / 443 / 441 / 445.
RA Removing and installing left cylinder head (M60)
BMW AG - TIS
14.02.2013 02:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
