7 Series E38 740iL (M60-2) SAL
Unfasten screws to sealing cover.
If necessary, unfasten oil cooler line bracket from oil pan.
Unfasten remaining screws from oil pan.
Lift upper section of oil pan forwards to remove.
Installation:
Sealing faces clean and free of seal debris. Coat contact
surfaces of joint with liquid gasket Hylomar SQ 32 M (refer
to BMW Parts Service).
1.
Replace gasket
2.
Install oil pan
3.
Insert all screws in the oil pan.
4.
Insert screws in transmission end without preload at this
stage.
5.
Tighten down screws in engine end.
6.
Tighten down screws in transmission end.
RA Removing and installing/replacing upper section of oil pan (M60)
BMW AG - TIS
14.02.2013 02:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -