bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

ABOUT US
3 RA Removing And Installing_sealing Or Replacing Timing Case Cover At Bottom (M60)|Page 540 > < 3 RA Removing And Installing_sealing Or Replacing Timing Case Cover At Bottom (M60)

7 Series E38 740iL (M60-2) SAL

Page 2
background image

Installation:

Secure chain and rails with plastic strap.

Installation:

Clean and remove grease from sealing surfaces of the engine
block.

Make sure dowel sleeves are correctly positioned.

Replace seals.

Installation:

Install timing case cover, insert all screws and initially tighten to
approx. 5 Nm.

Firmly tighten all screws in alternate sequence.

Tightening torque 11 14 1AZ.

Caution!

Once all screws have been tightened down, retighten them in
a second operation.

Note:

The timing case cover gaskets are designed as coated metal
gaskets.

RA  Removing and installing/sealing or replacing timing case cover at bottom (M60)

BMW AG - TIS

14.02.2013  02:47

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

3 RA Removing And Installing_sealing Or Replacing Timing Case Cover At Bottom (M60)|Page 540 > < 3 RA Removing And Installing_sealing Or Replacing Timing Case Cover At Bottom (M60)