7 Series E38 740iL (M60-2) SAL
Release expansion rivet (1) and lift insulating mat (2) to one side.
Unhook cable straps (1) and remove hydraulic hoses (2).
Installation:
Lay hydraulic hoses (2) parallel and without kinks to wiring
harness.
Remove retainers (1) and (2).
Lever out rubber grommet (3).
Lever out hydraulic cylinder (4) and remove with hydraulic hoses.
Remove hydraulic cylinder with hoses (4).
The hoses on the hydraulic cylinder must be sealed tight. To do
so, use the plugs and cap nuts from the "Hollow union bolts for
hydraulic cylinder" set.
Installation:
Check function.
RA Removing and installing/replacing hydraulic cylinder for trunk lid (electrohydra
BMW AG - TIS
14.02.2013 14:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -