bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

10 RA Removing And Installing Rear Window (Protection)|Page 2083 > < 10 RA Removing And Installing Rear Window (Protection)|Page 2081
Page 3
background image

Disconnect left plug connections (1) (rear window
heating/antenna).

Version with antenna for car telephone:

If necessary unfasten plug connection.

Note:

Place protective covers on side walls and middle of trunk lid.

The following two work steps must be carried out with a 2nd
person:

Remove retainer (1) and lift out left and right gas struts (2).

Loosen screw (3).

Release screw (4) and remove trunk lid.

Place trunk lid on the protective cover (1) and secure with fabric
adhesive tape (2) on left/right sides.

Caution!

Use only approved adhesive tape. The rear window coating
will be damaged if the wrong adhesive tape is used.

Secure cable (rear window heating/antenna) to rear window with
adhesive tape.

Mark cable entries on outside of rear window.

RA  Removing and installing rear window (Protection)

BMW AG - TIS

14.02.2013  14:45

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 3 -

10 RA Removing And Installing Rear Window (Protection)|Page 2083 > < 10 RA Removing And Installing Rear Window (Protection)|Page 2081