7 Series E38 740iL (M60-2) SAL
Suspend special tool 51 9 002 (suction lifter) from conventional
workshop lifting equipment.
Switch on vacuum pump.
Firmly attach special tool 51 9 002 to outside of rear window in
center in upper third.
Caution!
Follow operating instructions for special tool 51 9 002.
The pointer of the vacuum gauge must be in the green area.
Do not shorten connecting hose between suction hoist and
vacuum pump (minimum length 5 m).
Replacement with original hose only.
Lift rear window with special tool 51 9 002 over body cutout.
First install rear window carefully at top, align sides uniformly and
then install at bottom and press into place.
Remove special tool 51 9 002.
Align rear window with special tool 51 3 010. Gasket must locate
uniformly down each side (center carefully). Press rear window
upwards until there is a uniform gap between gasket and roof of
5 mm.
RA Removing and installing rear window (Protection)
BMW AG - TIS
14.02.2013 14:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -