7 Series E38 740iL (M60-2) SAL
(When applied to residual bead at least
15 minutes.)
Preparation for assembly:
Prepare plastic nozzle for the shaping of the glue bead (can be cut to size during the specified ventilation time).
The inside edge of the window is coated with a protective glue bead with a (black) UV-resistant glass ceramic layer
which must be treated as follows:
Treatment of glass ceramic surface (inside of window):
Glue
Treatment
Genuine BMW repair kit:
Part Number 81 22 9 407 497
Adhesive cartridge:
Part Number 81 22 9 407 526
or
SikaTack - Ultrafast or Sikaflex 255 FC
Caution!
Not for US cars!
a)
Carefully but firmly rub adhesive area with
Sidol.
b)
Wipe off Sidol residue with a new cloth.
c)
Repeat Points a) and b) with a new cloth.
d)
Rub adhesive area with alcohol (available
from pharmacies).
e)
Air drying time at least 1 minute.
f)
Apply a thin coat of glass primer 205/5 or
Sika 205/5 bonding agent.
g)
Air drying time at least 10 minutes
Caution!
Not for US cars!
a)
Rub adhesive area with alcohol (available
from pharmacies).
b)
Air drying time at least 1 minute.
c)
Apply a thin coat of glass primer 205/5 or
Sika 205/5 bonding agent.
d)
Air drying time at least 10 minutes
Version with viewing panel for vehicle number (VIN) in windshield (all except US):
Seal sight glass (bottom left) with Sika bonding agent 206 G+P.
Installation:
Caution!
Assembly must be completed within 10 minutes, otherwise the cement bead will form a skin which will not be
able to stick properly.
RA Notes on gluing windshield and rear window (Protection)
BMW AG - TIS
14.02.2013 14:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -