7 Series E38 740iL (M62) SAL
11 12 004
Removing and installing/sealing both cylinder
head covers (M62)
Note instructions on connecting and decoupling battery,
refer to General Information MG12
Disconnect negative battery lead.
Version 1
(acoustic cover screwed down)
Pry out sealing cap. Unscrew nuts.
Remove acoustic cover.
Version 2
(acoustic cover with press-stud fastener)
Open press-studs (1 ... 4) one at a time, at the same time lifting
the acoustic cover slightly. Once all four press-studs have been
opened, remove the acoustic cover.
Installation:
Position acoustic cover and press downwards until press-
studs (1 ... 4) click into place.
Remove suction-filter housing with air-mass sensor,
refer to 13 71 000
RA Removing and installing/sealing both cylinder head covers (M62)
BMW AG - TIS
17.02.2013 15:20
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -