7 Series E38 750iL (M73) SAL
Unfasten plug connection from temperature sensor for coolant
temperature.
Unfasten plug connection (1) from oil level sensor and starter
motor (2).
Slide cable duct backwards to remove from front interlock (1) then
lift it up (2).
At this point, the wiring harness is effectively removed, e.g. it was
possible to remove the intake air manifold.
Unfasten plug connection on impulse sensor on crankshaft
(flywheel) for DME of cylinder 1 - 6 (DME 1).
Installation:
Clip line from impulse sensor (2) into bracket (1).
RA Wiring harness - replacing engine section (M73)
BMW AG - TIS
20.02.2013 19:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
