7 Series E38 750iL (M73) SAL
33 32 064
Removing and installing or replacing left or
right swinging arm
Caution!
After installation:
-
Perform rear wheel alignment check/adjustment.
-
Check that output shaft is correctly seated in final drive.
Remove wheel.
Unclip cable from ABS impulse sensor.
Use peening tool to mark position of eccentric screw relative to
swinging arm.
This makes the subsequent camber adjustment easier when
reinstalling the previous swinging arm.
Unfasten disc collar nut.
Unscrew and remove eccentric screw.
Installation:
Replace disc collar nut.
Tightening torque, 33 32 22AZ.
RA Removing and installing or replacing left or right swinging arm
BMW AG - TIS
20.02.2013 22:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
