7 Series E38 750iL (M73) SAL
Remove outer brake lining.
Inner brake lining is located with its spring in the piston.
Important!
Mark any worn brake linings.
In the event of one-sided brake lining wear, do not change brake
linings round.
New brake linings may only be installed if the brake disk thickness
is greater than or equal to the minimum brake disk thickness (MIN
TH).
Observe minimum thickness of brake pads.
Clean brake linings.
Do not apply grease to brake pad backplate.
Check dust sleeve (1) for damage and replace if necessary.
Clean mounting face (2) of brake piston and apply a thin coating
of anti-squeak compound.
Refer to BMW Service Operating Fluids.
Important!
Dust sleeve must not come into contact with anti-squeak
compound as this may cause the dust sleeve to swell.
Clean mounting faces (1) and (2) of brake lining hammer
heads/brake caliper housing and coat with anti-squeak compound.
Refer to BMW Service Operating Fluids.
Note:
Grease contact surfaces on brake caliper at top and bottom.
Clean mounting face (3) of brake caliper and apply a thin coating
of anti-squeak compound.
Refer to BMW Service Operating Fluids.
RA Removing and installing/replacing brake linings on both front disk brakes
BMW AG - TIS
20.02.2013 22:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
