7 Series E38 750iL (M73) SAL
34 31 500
Removing and installing / replacing master
brake cylinder
Important!
Note "General Information",
refer to 34 00 ...
After the work steps are completed, bleed the brake
system, refer to:
Vehicles with ABS 34 00 047
Vehicles with ABS/ASC+T, DSC1, DSC2 34 00 048
Vehicles with DSC3 34 00 050
Suck the brake fluid out of the expansion tank. Use a suction
bottle used exclusively for drawing off brake fluid.
Pull off supply hose on clutch hydraulics (1).
Lift out the expansion tank (2) from the master brake cylinder by
tilting it laterally.
Installation:
Push the expansion tank vertically onto the master brake
cylinder.
Loosen the screw connections of the brake lines.
Note:
Close off the brake lines and the master brake cylinder using
the appropriate seal plugs.
Installation:
Tightening torque,
refer to Technical Data 34 32 1AZ
RA Removing and installing / replacing master brake cylinder
BMW AG - TIS
20.02.2013 22:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -