7 Series E38 750iL (M73) SAL
Unfasten brake lines.
Caution!
Do not mix up brake lines, mark before removing if necessary.
Installation:
Line connections
(F) from THZ circuit F to hydraulic control unit circuit F (front-axle
circuit)
(R) from THZ circuit R to hydraulic control unit circuit R (rear-axle
circuit)
(FR) from hydraulic control unit FR to front right wheel brake
(FL) from hydraulic control unit FL to front left wheel brake
(RR)from hydraulic control unit RR to rear right wheel brake
(RL) from hydraulic control unit RL to rear left wheel brake
Observe Tightening Torque,
refer to 34 32 1AZ
.
DSC
Unlock and disconnect plug connection (4) on pressure sensor.
Release screw (5) and remove hydraulic control unit; do not bend
brake lines in doing so.
RA Removing and installing/replacing hydraulic unit ABS/ASC+T, DSC3 from 09/98
BMW AG - TIS
20.02.2013 22:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
