7 Series E38 750iL (M73) SAL
34 52 515
Replacing ABS/ASC+T/DSC control module
from 09/98
Note:
Before removing the ABS/ASC+T/DSC control module, read
out the fault memory and if necessary print out the fault code.
After the control module has been installed, new control units
must be coded. On cars equipped with DSC, it is also
necessary to carry out an adjustment of the steering angle
sensor with DIS (Diagnosis and Information System) under
the menu item Service functions.
Carry out end-of-belt test with DIS (Diagnosis and Information
System).
Release lock on plug connection (1) in direction (2). Detach plug
connection (1) in direction (3) vertically toward top.
Installation:
Position plug connection (1) vertically on control module in
order to avoid damaging pins.
Release screws (1) and detach control module (2) from hydraulic
unit.
Installation:
Replace screws (1).
Check sealing face (1) for damage (visual inspection).
Clean sealing face (1); do not use any sharp-edged tools or
aggressive cleaning agents here.
Check contact lugs (2) for corrosion or damage.
Installation:
Replace hydraulic unit if sealing surface (1) or contact lugs (2)
is/are damaged.
RA Replacing ABS/ASC+T/DSC control module from 09/98
BMW AG - TIS
20.02.2013 22:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
