7 Series E38 750iL (M73) SAL
Test requirements:
Open trunk lid (by motor) once and then close again so as to
bleed the system.
Open trunk lid again (by motor).
When the cylinder is fully extended (trunk lid open), the fluid level
must be in area (A) of the marking (1) on the hydraulic control unit
(2).
Topping up fluid in hydraulic control unit:
If necessary, remove and install hydraulic control unit for boot lid
controls (electrohydraulic/fully automatic),
refer to 51 24 150.
Release oil filler plug (1) on hydraulic control unit (2). Add as much
hydraulic fluid (sourcing reference: BMW Parts Service) until it
reaches area of marking.
Fit a new oil filler plug (1) and seal.
Check fluid level again (refer to previous work step).
RA Information on automatic trunk lid controls (electrohydraulic)
BMW AG - TIS
21.02.2013 01:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
