7 Series E38 750iL (M73) SAL
Maintain the distance (A) of the upper glue bead to the gasket,
(B) at side and (C) bottom along the windshield edge.
Caution!
To ensure that the water drainage channel of the slide/tilt
sunroof is not sealed with adhesive,
proceed as follows:
In corners of seal at top and
at break in sealing lip,
continue drawing adhesive bead uniformly.
Maintain distance (B) at side and (C) at bottom along edge of
windshield.
(A) 1 mm
(B) 2 mm
(C) 4 mm
Note:
Adhesive area for plastic adhesive tapes (1) must be free of
grease and dust.
Attach two yellow plastic adhesive tapes (1) (Tesa)
to roof at a distance (A) from outer corners.
Length: 400 mm
Width: 50 mm
(A) 250 mm
Using special tool 51 3 010,
first position windshield at top,
align evenly at sides,
then install at bottom and press into position.
Press windshield upwards until seal contacts
roof uniformly.
Secure windshield in this position on top with two yellow plastic
adhesive tapes (1) (Tesa).
Preload on top of windshield to prevent wind noise:
RA Removing and installing front windscreen
BMW AG - TIS
21.02.2013 01:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
