7 Series E38 L7 (M73) SAL
11 00 050
Removing and installing engine (M73)
Note instructions on connecting and decoupling battery,
refer to General Information MG12
Disconnect negative battery lead.
Lift engine hood into assembly position.
Disconnect damper on hood, open hood fully and secure with a
screw on left and right sides.
Remove left and right heat baffle plates on front axle support.
Unfasten drain plug for coolant in left and right engine block.
Drain and dispose of coolant.
Installation:
Replace seals.
Tightening torque,
refer to Technical Data 11 11 5AZ
Remove automatic transmission,
refer to 24 00 026
Remove complete radiator,
refer to 17 11 000
Remove left and right upper sections of intake filter housing with
mass air flow sensor,
refer to 13 71 010 / 13 71 020
Remove complete main flow oil filter,
refer to 11 42 020
RA Removing and installing engine (M73)
BMW AG - TIS
21.02.2013 22:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
