7 Series E38 L7 (M73) SAL
11 53 325
Removing and installing / replacing coolant
manifold (M73)
Remove both cylinder head covers,
refer to 11 12 004
Remove splash guard.
Remove left heat baffle plate from front axle support.
Unfasten coolant drain plug from left side of engine.
Drain off coolant and dispose of correctly.
Installation:
Replace sealing ring
For tightening torque,
refer to Technical Data 11 11 5AZ
Top up coolant.
Bleeding cooling system and checking for water leaks,
refer to 17 00 039
Mark plug connection of impulse sensor on crankshaft (flywheel),
press down interlock on connector and disconnect the connector.
Impulse sensor for the DME 1
Mark plug connection for impulse sensor on the crankshaft
(flywheel), press down interlock on connector and disconnect the
connector.
Impulse sensor for the DME 2
Unclip wiring harness on transmission and remove from brackets
behind the cylinder head.
RA Removing and installing / replacing coolant manifold (M73)
BMW AG - TIS
21.02.2013 22:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
