7 Series E38 L7 (M73) SAL
The depth to the pulse teeth of the flywheel must be determined
with special tool 00 2 407.
Note depth.
Measure depth (A) of pulse sensor.
Deduct depth (A) of pulse sensor from depth of flywheel. This
result is the gap dimension.
Adjust a gap dimension of 0.55
±
0.2 mm with the shims.
The dimension 0.55 mm should be achieved as exactly as
possible in order to:
1. Enable exact misfiring recognition.
2. Prevent pulse sensor from contacting pulse teeth.
Refer to BMW Parts Service for shims.
Installation:
Interrogate fault memory of control unit on Digital Motor
Electronics (DME), check fault messages in memory, rectify
faults and cancel fault memory.
RA Replacing impulse sensor (cylinder bank 1-6) (M73)
BMW AG - TIS
21.02.2013 23:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -