bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

6 RA Replacing Right Knock Sensors (cylinder Bank 1-6)(M73) > < 4 RA Replacing Sensor For Cylinder Recognition (camshaft Sensor) (M73)
Page 1
background image

12 14 570

Replacing control unit for electric catalytic
converter (M73)

Switch off ignition.

Instructions for disconnecting and connecting battery,

refer to General Information MG12.

Disconnect and cover both negative leads from batteries.

Note:

Remove and install passenger seat,

refer to 52 17 000.

Remove inner entrance cover strip, front right.

Remove finisher on A-pillar, bottom right.

Lift floor carpet at front and rear and lay to one side.

Lift out expansion rivet (1). Raise air duct a little.

Disconnect plug connections on control unit (3).

Release screws (2).

Remove control unit (3).

RA  Replacing control unit for electric catalytic converter (M73)

BMW AG - TIS

21.02.2013  23:28

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

6 RA Replacing Right Knock Sensors (cylinder Bank 1-6)(M73) > < 4 RA Replacing Sensor For Cylinder Recognition (camshaft Sensor) (M73)