7 Series E38 L7 (M73) SAL
Carefully push control module (1) onto hydraulic unit (2).
Make sure that solenoid coils do not tilt.
Housing edge of control module (1) must slide over extension on
hydraulic unit (2).
Press control module onto hydraulic unit and screw in screws
(1+2) evenly (do not tighten down) until control module is resting
evenly on hydraulic unit.
Insert screws (1-6), do not tighten down yet.
Tighten down screws (1-6) in specified sequence with torque
wrench.
Installation:
Use only new screws, observe tightening torque,
refer to 34 51 1AZ.
RA Replacing ABS/ASC+T/DSC control module from 09/98
BMW AG - TIS
22.02.2013 03:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
