7 Series E38 L7 (M73) SAL
Adapt closing plate units compartment (1) to fit partition wall
carrier plate (2).
Mark out holes for plug-welding.
Remove closing plate from units compartment.
Drill holes in closing plate units compartment for plug welding.
Clean connection faces on closing plate units compartment and
front wheel arch.
Adjust closing plate units compartment (1) and weld to front wheel
arch and partition wall carrier plate (2).
Grind welding spots until smooth.
Drill holes for plug welding on transmission tunnel reinforcement
plate in area (1).
Clean up connection point.
RA Replacing front section of engine support to left wheel arch
BMW AG - TIS
22.02.2013 04:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
