7 Series E38 L7 (M73) SAL
Cut out connection points between wheel arch, wheel arch
extension and side member approximately.
Caution!
Do not damage the strengthening support on rear axle.
Using force, separate the connection for the crossmember.
Caution!
Do not damage the floor group!
Remove the trunk floor.
Separate the upper section of the side member to approx. the
middle of the spring support.
Dimension A = 100 mm from hole
∅
12 mm in side member.
Remove scrap metal.
On vehicle:
Drill the holes for the plug welding connection on trunk floor /
spare tire compartment.
Drill the holes for the plug welding connection on trunk floor /
crossmember.
Drill the upper holes for the plug welding connection on side
member.
RA Replacing complete rear trunk floor (rear left side panel and tail panel removed
BMW AG - TIS
22.02.2013 04:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -