7 Series E38 L7 (M73) SAL
Align hood lid against front side panels at same seam width with
parallel seams,
refer to 41 00 ... gap dimensions doors / Front and trunk lid.
Align hood lid against front side panels.
The hood lid should close flush with the front side panels beside
the headlights.
Tolerance - 1 mm, i.e the hood lid must be set 1 mm back from
the side panels.
Align hood lid with front side panels.
The hood lid beside the windshield should seal flush with the side
panels at the front.
1 = Front lid
2 = Side panel, front
This arises as a result of adjustment of hood lid beside headlights.
Note:
Adjustment of hood lid next to headlights must always be
within specified tolerance range.
Retighten loosened bolts.
Adjust height of engine hood on the hinges:
Close engine hood carefully.
Measure height of hood lid at (B).
Dimension (A) = 200 mm from the relevant outside edge of the
side panel (on headlight or on windshield).
The hood lid should be set to the same height as the front side
panels in area (B).
Tolerance - 1 mm, i.e. hood lid must lie 1 mm below side panels.
RA Aligning engine hood
BMW AG - TIS
22.02.2013 04:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -