7 Series E65 735i (N62) SAL
Remove both oxygen control sensors
Release negative lead on engine support arm.
Remove vibration damper and tensioning pulley from A/C compressor drive
belt
Release power steering pump on bracket, hydraulic lines remain connected.
Do not remove power steering
pump, secure against falling down.
Release A/C compressor on bracket, lines remain connected, do not
evacuate A/C system.
Do not remove A/C compressor,
secure against falling down.
Release ABS control unit on bracket, lines remain connected.
Do not remove ABS control unit,
secure against falling down.
Remove lower universal joint of steering spindle
Vehicles with Dynamic Drive only:
Unlock and detach hydraulic line (1).
Suspend engine off-center from special tool 11 0 000 .
Release engine mounts on left and right from above.
Protect assembly compartment and hydraulic lines against
damage.
Installation:
Observe specified tightening torque and safety precautions in all
work steps.
RA Removing and installing engine (N62 / N62TU)
BMW AG - TIS
08.02.2013 02:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
