7 Series E65 735i (N62) SAL
Remove special tool 11 9 473 .
Remove bearing bracket (1) from special tool 11 9 470 .
Important!
Do not tilt bearing bracket (1).
Lower bearing bracket (1) from above and carefully bring into
contact with cylinder head.
Insert nuts and tighten by hand without play.
Important!
Make sure none of the intermediate levers or rocker arms
have slipped out.
Tighten down nuts from inside to outside.
Tightening torque 11 31 1AZ
.
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Fit bearing cap R E1 in such a way that marking is legible from
inlet side.
Install nuts and tighten down.
Tightening torque 11 31 1AZ
.
Rotate inlet camshaft in direction of rotation until cam on 5th
cylinder points upwards at an angle as shown in illustration.
Note:
The marking (1) on the hexagon drive of the inlet camshaft faces
upwards.
RA Removing and installing/replacing rocker arms on left inlet side (N62 from 9/03
BMW AG - TIS
08.02.2013 03:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
