7 Series E65 735i (N62) SAL
Release 8 nuts of bearing bracket (1) from outside to inside.
Note:
Rocker arms are freely accessible after bearing bracket has been
removed.
Do "not" remove rocker arm (1) on inlet side.
Important!
Rockers arms (1) are divided into individual tolerance
classes.
The tolerance classes are designated as illustrated with the
numbers from 1 to 4.
Used rocker arms (1) may only be reused in the same
position.
When replacing rocker arms (1) on inlet side: install rocker arms
of the same tolerance class in the same position.
Clamp special tool 11 9 470 as illustrated in a vise.
Important!
Do not tilt bearing bracket (1).
Carefully lift out bearing bracket (1).
RA Removing and installing/replacing left intermediate lever (N62 to 9/03)
BMW AG - TIS
08.02.2013 03:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
