7 Series E65 735i (N62) SAL
Rotate inlet camshaft against direction of rotation until
lettering (1) on 8th cylinder points upwards in cylinder axis and
cam is horizontal.
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Note:
Bearing caps of inlet camshaft are marked on cylinder bank 5
to 8 with R E1 to R E5 from inlet side.
Release nuts and remove bearing cap R E1.
Release 8 nuts of bearing bracket (1) from outside to inside.
Note:
Rocker arms are freely accessible after bearing bracket has been
removed.
Do "not" remove rocker arm (1) on inlet side.
Important!
Rocker arms (1) are divided into individual tolerance classes.
The tolerance classes are designated as illustrated with the
numbers from 1 to 4.
Used rocker arms (1) may only be reused in the same
position.
When replacing rocker arms (1) on inlet side: install rocker arms
of the same tolerance class in the same position.
RA Removing and installing/replacing left intermediate levers (N62 from 9/03 and N6
BMW AG - TIS
08.02.2013 03:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
