7 Series E65 735i (N62) SAL
Unscrew nut (special tool 11 9 473 ).
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Note:
Bearing caps are marked in graphic with R E2 to R E5.
Remove bearing caps R E2 to R E5 and place to one side in
order.
Lift out inlet camshaft (1).
Note:
Further tasks:
The section Removing and installing left eccentric shaft contains
important installation instructions.
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
08.02.2013 02:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
