7 Series E65 735i (N62) SAL
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Fit bearing cap R E1 in such a way that marking is legible from
inlet side.
Install nuts and tighten down.
Tightening torque 11 31 1AZ
.
Rotate inlet camshaft in direction of rotation until cam on 5th
cylinder points upwards at an angle as shown in illustration.
Note:
The marking (1) on the hexagon drive of the inlet camshaft faces
upwards.
Install inlet and exhaust adjustment unit on left side.
Install spark plugs on cylinder bank 5 to 8.
Install left cylinder head cover.
Install ignition coils on cylinder bank 5 to 8.
Install servomotor for left eccentric shaft.
Assemble engine.
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
08.02.2013 02:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -
