7 Series E65 735i (N62) SAL
Important!
Make sure screws of inlet and exhaust adjustment units have
been slackened off.
Crank engine at central bolt from 45
°
before TDC position in
direction of rotation to firing TDC position.
Secure vibration damper with special tool 11 9 190 in firing
TDC position of 1st cylinder.
Note:
When tightening down screw (1), grip camshaft at hexagon head.
Tighten down screw (1) of inlet adjustment unit.
Tightening torque 11 36 16AZ
.
Release screw (1) and remove special tools 11 9 463 /
11 9 461 from inlet camshaft.
Place special tool 11 9 462 on exhaust camshaft and align
exhaust camshaft so that special tool 11 9 462 rests without a
gap on cylinder head.
RA Removing and installing/replacing inlet and exhaust adjustment units on right si
BMW AG - TIS
08.02.2013 03:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -
