7 Series E65 735i (N62) SAL
11 36 715
Removing and installing/replacing both left
solenoid valves (N62/N62TU)
(cylinder bank 5 to 8)
Necessary preliminary tasks:
•
Read out fault memory of control unit of Digital Motor
Electronics (DME)
•
Switch off ignition
•
Remove design cover
•
Unlock hose on tank venting valve and disconnect.
Note:
Solenoid valve (1) controls adjustment unit on inlet side.
Solenoid valve (2) controls adjustment unit on exhaust side.
Unlock plug of solenoid valves (1 and 2) and disconnect.
Release screws and remove holder (3).
Pull out solenoid valves (1 and 2).
Installation:
Check holder (3) for deformation; replace if necessary.
Installation:
Clean sealing faces (1) on cylinder head.
Installation:
Replace O-rings (1 and 2) on solenoid valve (3) and lubricate.
RA Removing and installing/replacing both left solenoid valves (N62/N62TU)
BMW AG - TIS
08.02.2013 03:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
