7 Series E65 735i (N62) SAL
Removal of lever (2) with roller (if necessary):
Important!
Levers with rollers of cylinders 1 to 4 and 5 to 8 are
different and must not be mixed up.
Grip lever (2) with roller at dihedral.
Release screw (1) and remove lever (2) with roller from
eccentric shaft.
Important!
Needle bearings (1) break off very easily when removed and
installed.
Carefully press needle bearings (1) apart at split position only to
such an extent that they can be removed from eccentric shaft.
Note:
If the needle-roller bearings are replaced, the bearing shells must
be replaced as well.
Carefully press bearing shell (1) to one side and simultaneously
remove towards top.
Installation
Installation of eccentric shaft is described separately from
removal.
RA Removing and installing/replacing left eccentric shaft (N62 to 9/03)
BMW AG - TIS
08.02.2013 03:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
