7 Series E65 735i (N62) SAL
Rotate inlet camshaft against direction of rotation until
lettering (1) on 8th cylinder points upwards in cylinder axis and
cam is horizontal.
Rotate eccentric shaft at dihedral head as illustrated in order to
reduce tension on torsion spring (1).
Pretension torsion spring (1) with a cable strap (2), feed out
from roller (3) and carefully relieve tension.
Rotate eccentric shaft at dihedral head as shown in illustration
back to minimum stroke position.
Important!
Do not mix up the camshaft bearing covers of
cylinders 1 to 4 and 5 to 8.
Note:
Bearing caps of inlet camshaft are marked on cylinder bank 5
to 8 with R E1 to R E5 from inlet side.
Release nuts and remove bearing cap R E1.
RA Removing and installing/replacing left intermediate lever (N62 to 9/03)
BMW AG - TIS
08.02.2013 03:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
