7 Series E65 735i (N62) SAL
Release bolts (1) and modify manifold with charge-air pressure
actuator to new radial compressor.
Installation:
Tightening torque: 9 Nm.
Important!
Follow instructions in the next work step.
Make sure that spacer sleeve (1) is modified in new radial
compressor.
Seal (2) must always be replaced.
Release screws (1) and modify manifold (2) to new radial
compressor.
Installation:
Replace seal.
Tightening torque: 9 Nm.
RA Removing and installing/replacing charger (BMW ALPINA B7 radial compressor)
BMW AG - TIS
08.02.2013 03:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
