7 Series E65 735i (N62) SAL
11 37 700
Replacing control unit (Valvetronic)
Switch off ignition.
Follow instructions for disconnecting and connecting battery.
Disconnect battery.
Caution!
Follow instructions for removing and installing electronic
control units.
Observe following instructions before replacing control unit:
Program control unit.
Remove right fresh air duct.
Release screw and remove holder (1).
Release screws and remove cover (2) from control unit box.
Note:
Release screws on seal (3) only when removing wiring harness.
Installation:
Insert tabs (1) in openings (2) and close cover.
Unlock and detach plug connections on Valvetronic control
unit (1).
Remove Valvetronic control unit (1).
RA Replacing control unit (Valvetronic)
BMW AG - TIS
08.02.2013 03:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
