7 Series E65 735i (N62) SAL
13 53 240
Replacing complete injection pipe (N62,
N62TU)
Special tools required:
•
13 5 281
Necessary preliminary tasks:
•
Read out fault memory of DME control unit; if necessary,
work through test schedules
•
Switch off ignition
•
Remove acoustic cover
•
E65 only:
Remove design cover
•
Remove ignition coil covers
Unlock plugs (1) on servomotors and disconnect.
Detach plug connections (2) of knock sensors from cable strips.
Unclip cable (3).
Unlock and disconnect following plug connections.
-
Fuel rail, left and right, on cable duct
-
Throttle-valve assembly
-
All solenoid valves
-
Both temperature sensors
-
Oil-pressure switch
-
Tank venting valve
-
Alternator
-
Differential pressure sensor
RA Replacing complete injection pipe (N62, N62TU)
BMW AG - TIS
08.02.2013 04:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
