7 Series E65 735i (N62) SAL
Unlock holder (1) and remove.
Note:
Texts refer to and illustrations show the left side. The procedure is
identical for the right side.
Lower radiator core in direction of arrow, set down on floor and
secure against falling over. Remove special tool 11 0 020 .
Installation:
Make sure rubber mounts are correctly seated on module carrier.
(Rubber mounts can fall off)
Installation:
When installing radiator core, make sure radiator core (1) and air
duct (2) are correctly positioned.
Check stored fault messages.
Clear fault memory
Add coolant
Check power steering fluid level
Bleed power steering unit
Check oil/fluid levels in engine and in automatic transmission,
refer to Maintenance and General Information HG00.
Check all coolant lines/hydraulic lines for leaks
RA Removing and installing/replacing radiator core (BMW ALPINA B7)
BMW AG - TIS
08.02.2013 04:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -