7 Series E65 735i (N62) SAL
17 11 046
Removing and installing/replacing module
carrier
Work step
Note:
Remove design cover.
Remove fan clutch.
Remove fan cowl.
Drain coolant.
Remove radiator.
Remove auxiliary fan.
Draw off fluid from power steering.
Unlock hydraulic lines on cooling loop and disconnect.
Installation:
Top up hydraulic fluid.
Bleed power steering.
Check fluid level in power
steering fluid reservoir; top
up if necessary.
Lift module carrier out of rubber mounts and push approx. 5 cm towards rear.
Installation:
Rubber mounts fall out
easily, ensure correct
installation position.
Remove module carrier (1) towards bottom.
Note:
Secure A/C condenser against damage and against falling down.
When replacing module carrier:
Convert power steering cooling loop.
RA Removing and installing/replacing module carrier
BMW AG - TIS
08.02.2013 05:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
