7 Series E65 735i (N62) SAL
18 40 020
Removing and installing/replacing right
exhaust manifold (N62, N62TU)
Warning!
Scalding hazard!
Only perform these tasks on an engine that has cooled down.
Necessary preliminary tasks:
•
Remove right control sensor
•
Remove right monitor sensor
•
Remove complete exhaust system
•
Secure engine in installation position with special tool
•
E65 only:
Remove intake filter housing
•
Lower front axle support
•
E65 only:
Remove A/C compressor drive belt
•
Remove right engine support arm
•
BMW ALPINA B7 vehicles:
-
Remove exhaust temperature sensor
Release screw connection of A/C compressor.
Place A/C compressor to one side and secure A/C system line so
as to improve accessibility to nuts on exhaust manifold.
For purposes of clarity, nuts are shown on removed engine.
Release nuts on exhaust manifold.
Remove exhaust manifold towards bottom and pull out towards
rear.
RA Removing and installing/replacing right exhaust manifold (N62, N62TU)
BMW AG - TIS
08.02.2013 05:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
