7 Series E65 735i (N62) SAL
M67 only:
-
Release screws.
-
Remove holder.
Release screw (1).
Pull hydraulic lines (2) to transmission fluid cooler out of
transmission housing.
N73 only: Release holder for oil lines on engine.
Installation:
Replace sealing rings.
BMW ALPINA B7 only
Pay attention to thermostat (2) when removing hydraulic
lines (1)
Crank engine at central bolt in direction of rotation until a torque
converter retaining screw is visible in opening.
Release retaining screws with special tool 24 1 110 .
Crank engine further and release remaining 3 bolts.
Tightening torque 24 40 1AZ
.
RA Removing and installing automatic transmission (6HP26Z/6HP32Z)
BMW AG - TIS
08.02.2013 05:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -