7 Series E65 735i (N62) SAL
With a screwdriver, press constant-velocity joint (at the
disassembly grooves) off input flange.
Important!
Do not let propeller shaft fall into joints. Joint and rubber
sleeve on constant-velocity joint may be damaged.
Brace propeller shaft on center mount and loosen nuts.
Installation:
Tightening torque: 26 11 6AZ.
Bend propeller shaft downwards on center bearing.
Remove propeller shaft from transmission output flange and
remove constant-velocity joint from final drive.
Note:
Protect constant-velocity joint from dirt with transport cap.
RA Removing and installing complete propeller shaft
BMW AG - TIS
08.02.2013 05:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
