7 Series E65 735i (N62) SAL
Lower front axle carrier.
Version with Dynamic Drive:
-
Remove pressure lines for oscillating motor of front axle with
hose/pipe holders
-
Remove vent hose with filter
Remove heat shield(s).
Disconnect hydraulic lines from power steering gear and front axle
carrier.
Remove engine mount/mounting bracket on both sides and if
necessary remove with vacuum lines from front axle carrier.
Remove power steering gear.
E65, 66: Remove vehicle jack support.
Take front axle carrier down and set down on a suitable surface.
Installation:
Use previous front axle carrier as a template for modifying or
replacing small parts.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
•
If necessary, carry out initial Dynamic Drive operation
RA Replacing front axle carrier
BMW AG - TIS
08.02.2013 06:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -