7 Series E65 735i (N62) SAL
Release nut (1); if necessary, grip at hexagon head.
Remove guide arm from wheel carrier.
Installation:
Keep tapered pin and bore clean and free from oil and grease.
Replace self-locking nut.
Tightening torque 33 32 4AZ
.
Mark position of eccentric screw (4) to rear axle carrier.
Release nut (2) and remove eccentric washer (3).
Remove eccentric screw (4) towards rear.
Remove guide arm downwards.
Installation:
Note insertion direction of eccentric screw (4).
Align eccentric screw (4) by means of marking to rear axle carrier.
Fit eccentric washer (3).
Replace nut (2).
Tightening torque 33 32 5AZ
.
After installation:
•
Perform chassis alignment check
RA Replacing a guide arm
BMW AG - TIS
08.02.2013 07:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
