7 Series E65 735i (N62) SAL
34 31 505
Removing and installing / replacing master
brake cylinder for DSC
Special tools required:
•
32 1 270
Necessary preliminary tasks:
•
Read and comply with General Information.
•
Remove expansion tank.
Observe safety instructions on raising the vehicle.
After completing tasks, bleed brake system.
Unfasten brake lines.
Installation:
Tightening torque 34 32 1AZ.
Seal off brake lines and brake master cylinder with special tool
32 1 270 (plug).
Release nuts and withdraw brake master cylinder from brake
booster.
Installation:
Replace self-locking nuts.
Tightening torque 34 31 1AZ.
RA Removing and installing / replacing master brake cylinder for DSC
BMW AG - TIS
08.02.2013 08:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
