7 Series E65 735i (N62) SAL
37 14 515
Replacing rear left or right ride-height sensor
Important!
Observe safety instructions for raising the vehicle.
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection)!
Disconnect plug connection (1).
Release nut (2) and disconnect jointed rod.
Tightening torque 37 14 7AZ
.
Release screws (4) and remove ride-height sensor.
Installation:
Sensor lever (3) must point outwards from ride-height sensor.
Tightening torque 37 14 6AZ
.
After installation:
•
Version with ride-height control: Carry out ride-height-
calibration
•
Check headlight adjustment, correct if necessary
RA Replacing rear left or right ride-height sensor
BMW AG - TIS
08.02.2013 09:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
