7 Series E65 735i (N62) SAL
Door lock must be at zero current with Soft Close Automatic
(risk of damage).
Installation:
-
Install door lock and insert screws (1), do not tighten down.
-
Slide special tool 51 2 190 into opened rotary latch until
latch engages in first stage.
Installation:
-
Pretension door lock (1) with knurled screw (2) until special
tool 51 2 190 just contacts corner points (3).
Important!
To tension door lock (1), it is only permitted to turn knurled
screw (2) by a further 1 to 1.5 turns (max.) (risk of
damage).
Door lock seal must be uniformly positioned (water ingress).
-
Tighten down door lock screws (1), tightening torque
51 21 1AZ
.
Note on installation (driver's side only):
Feed paddle (1) into bushing (2) from below.
Installation:
Bowden cable (1) and fibre optics cable (2) must be routed
below bridge (3).
No fibre optics cables are fitted from build date 04/2004.
RA Removing and installing/replacing door lock in left or right front door
BMW AG - TIS
08.02.2013 11:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
