7 Series E65 735i (N62) SAL
51 31 242
Replacing rubber frame (bottom) for rear
window
Necessary preliminary tasks:
•
Remove both trim strips from roof frame.
Caution!
Rubber frame (1) is reinforced with an aluminum strip.
Pull off rubber frame (1) carefully in direction of arrow (rear
window breakage).
Note:
Tear-off tab on left/right may be bonded to adhesive.
When rubber frame (1) is removed, tear-off lip on left/right may
tear off and remain in vehicle.
Installation:
Gap (A) between rubber frame (1) and rear window corner (2)
must be the same on left/right.
Installation:
Replacement of rubber frame without rear window removal:
Detach tear-off tabs (2) from rubber frame (1).
If adhesive has managed to get onto bridge, this area must be cut
out partially.
Replacement of rubber frame with removed or new rear window:
Fit rubber frame with tear-off tabs (2).
3
Aluminum strip
RA Replacing rubber frame (bottom) for rear window
BMW AG - TIS
08.02.2013 12:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
